How to Perform a Complete Fluid Check on Your Car > 자유게시판

Regular fluid inspections are among the easiest ways to protect your car’s long-term health

Start by parking your car on a level surface and turning off the engine

Let it sit for a few minutes so the fluids can settle

Find each fluid container and dipstick under the hood—consult your manual if unsure

Begin with the engine oil level

Remove the dipstick, wipe off any residue with a lint-free cloth, fully reinsert it, and withdraw it once more

Ensure the oil level rests within the designated range marked on the dipstick

The fluid must be clean and light-colored—avoid if it’s murky, sludgy, or contains particles

If the level is below minimum, اتوسرویس داوود refill using the viscosity and specification listed in your manual

Move on to evaluating your engine coolant

Look at the translucent overflow tank, not the radiator cap, unless the engine is cold

The coolant must sit between the "MIN" and "MAX" indicators for both temperature states

Never open the radiator cap when the engine is hot

Add only the manufacturer-recommended coolant type mixed with water in the correct ratio

Now check the brake fluid

It’s commonly located on the driver’s side near the back of the engine bay

The fluid should be clear and at the full mark

A low brake fluid level may signal a leak, failing caliper, or worn brake components—get it checked immediately

For automatic transmission fluid, start the engine and let it idle in park

Wipe the stick clean, reinsert it completely, then pull it out again to assess both position and appearance

It must not appear dark brown or emit a burnt smell—this signals degradation

Replace the fluid immediately if it’s discolored or has a charred scent

Don’t forget the power steering reservoir if your car is equipped with it

Look for a small container labeled clearly, often with a cap that has a dipstick built in

Add fluid only if below the minimum line, using the specified type

Last, check your washer fluid reservoir

Simply glance at the tank and refill when the level is near empty

Choose a solution rated for your region’s lowest expected temperature

Once done, snap all caps and dipsticks back into place tightly

Maintain a simple log of each inspection and the fluids you replenished

Making this a monthly habit reduces the risk of sudden failures and keeps your car running for years